Archived posting to the Leica Users Group, 2007/01/06
[Author Prev] [Author Next] [Thread Prev] [Thread Next] [Author Index] [Topic Index] [Home] [Search]Hi Steve, I had the same happen on a 24 asph not too long ago. There are three very small inset screws set at 120 degrees one from the other on the front barrel that get loose over time. You'll need a very tiny Allen wrench to tighten them. You can also use a mini Phillips screwdriver small enough to engage the angles of the hexagonal socket in the screw heads. I hope this helps. Best, Ed El 06/01/2007, a las 22:08, Steve Barbour escribi?: > > On Jan 6, 2007, at 5:59 PM, Frank Filippone wrote: > >> Steve.. my suggestion will only work for the outer ring, the one >> that touches he rubberized surface. After that, you are not going >> to get any results from my input. Internal rings are a totally >> different affair, and I have no idea..... > > thanks Frank, for your input...the lens seems to work fine, nothing > is loose now, and likely I will have it looked at soon by a local > leica repair guy, or send it off if I have to... > > > Steve >> >> Frank Filippone >> red735i@earthlink.net >> >> >> >> thanks Frank , I will try it... though I believe the part/lens that >> was turning is inset, and below the level of the edge...which does >> not turn. Steve >> >> >> >> _______________________________________________ >> Leica Users Group. >> See http://leica-users.org/mailman/listinfo/lug for more information > > > _______________________________________________ > Leica Users Group. > See http://leica-users.org/mailman/listinfo/lug for more information >